Spring Car maintenance Guide

First, check the engine oil
The vehicle is parked on a level surface. Unplug vernier check the oil quantity, if in the (F) and (L) is two standard lines belong to the normal range, if less than (L). You should add the specified models oil, after liquid fuel can't be higher than (F).
Second, check the engine coolant level
When the engine warm-up state, don't open the radiator cap, otherwise you might be burned by spilled coolant or high temperature steam. Such as the engine cooling, check the coolant level should be between full and low bit, or should add distilled water or purified water (not mineral water plus) or frozen liquid, liquid level water does not exceed the full bit. If found cooling liquid decrease rapidly in a short time launch x431 pro plus, should be checked the cooling system whether leaks or go to service station to repair.
Third, the braking surface inspection
If the brake fluid is close to the lower limit or below the lower limit means that the system may have a leak or excessive brake shoe wear should be timely maintenance to the service station.
Additional brake fluid, we should pay attention to add the same type of brake fluid, to prevent damage to the cup, attention to protecting the paint to prevent corrosion paint.
Fourth, the clutch master cylinder surface inspection
Clutch level between high and low level between said normal, if less than the standard line, it may be damaged master cylinder or wheel cylinder cup.  The engine operating status appears difficult or impossible to hang hanging file behavior, to the nearest service station immediate overhaul.
Fifth, the battery maintenance checks
Check the battery is firmly fixed electrolyte should be between the upper and lower limits, close off the assembly line should be timely additional electrolyte or distilled water to the high line. Positive and negative battery cables to keep good contact, and keep the battery clean and dry. Place a long time to take off the positive and negative vehicle battery cables, separated by about half rewired about 20 minutes after starting the engine, if the battery is clearly insufficient to timely charge.
Sixth, check the tire
At room temperature should be checked every month about tire pressure, if less than the normal standard tire pressure should be promptly added. Pressure is not too high or too low or affects driving safety.
Check the tires for cracks, there are security risks should be timely replacement tires.
The selection of tires should be made consistent with the model.
Seventh, belt check
Usually when you start the engine or drive a vehicle belt hair ring, a long-term situation is not checked belt adjustment caused by normal standards can be adjusted. Another case is a test of aging, need to be replaced.
Eighth, air filter inspection
Dirty air filter will cause poor engine, fuel consumption is too large, damaged engines, while checking the air filter, if found less dust, blocking light, can be used high-pressure air to blow out from the net, continue to use. Too dirty air filter should be replaced.
Ninth, spark plug inspection
Normal spark plug insulating ceramics is intact. No rupture leakage OBD2 Scanner, spark plug gap 0.8 +-0.0mm discharge, sparks is blue, stronger. If you find abnormal need to adjust abnormal gap or replace the spark plug.
Tenth, check the fuel filter
If it is found poor oil fuel filter should be checked for blockage, such blockage should be replaced.
Some car diagnostic tools can help you test your car by yourself, such as:

Related Links

28 Sep 2015